How to Buy and Maintain a Horton Fan Clutch
The Horton fan clutch has an important function in a truck’s operation, yet it is one of the most overlooked and least maintained components. Here is a note on how the Horton fan clutch works, what maintenance it requires and importantly what to keep an eye on.
A Horton fan clutch’s prime function is to engage and disengage the engine fan with a clutch controlled by an air-actuated solenoid valve. On modern vehicles the solenoid receives signals to turn on and off from the engine’s ECU. On older trucks, the signals are sent from the temperature sensor.
The clutch engages and makes the fan turn when the valve opens, sending air pressure to overcome a spring and push the Piston Friction Disc (PFD) against the friction material. It disengages when the valve closes, allowing the clutch solenoid to exhaust air and let the spring return.
Most vehicles also have a manual override switch which will allow the driver to activate the fan on the approach to a hill to bring the engine temperature down. Conversely, on a long descent a professional driver will manually activate the fan to help aid engine retardation, because the fan soaks up 30 to 40 horsepower.
How does the Horton Fan Clutch work?
In the event of fan clutch slippage, heat builds up at the outer edge of the Piston Friction Disc (PFD). This heat works its way toward the centre of the fan clutch. When damaging levels of heat reach the System Sentry the fuse will melt. This allows air pressure in the fan clutch to drop, disengaging the fan clutch immediately.
When the System Sentry has released the fan clutch, it has done this to protect your investment. This protective action also alerts you that there is a problem, so you can troubleshoot and repair the problem immediately. Catching problems in the early stages will keep damage and downtime to a minimum
Fan blades should be checked for correct clearance to the radiator, shroud and engine components. Check, locate and remove anything that may be an obstruction to the fan blade. Check that there are no cracks or splits in the fan blades that might cause the fan to run out of balance.
A fan clutch needs 100 psi (6.8 bar) for solid engagement. Look for a problem that is causing partial engagement – usually air leaking past the solenoid valve seals into the airline causing a pressure build-up. Is there a pressure drop causing partial disengagement? This usually is caused by an inoperative solenoid, airline blockage, up-stream air leaks, air leaks from the fan clutch body itself or low air pressure.
Routine inspection of the Horton Fan Clutch should be carried out at 200,000km intervals. Remove and plug airlines at the Fan Clutch input. Loosen fan belts, rotate the pulley and feel for smooth rotation of bearings. Repeat this procedure on the front section of the fan clutch. Check friction facing for wear, the friction facing should be approximately 4mm thick.